Betaflight Setup

Canvas Mode

Currently only Betaflight supports msp_displayport settings in the CLI. For INAV please refer to the respective guide in this wiki. Please make sure that the FC firmware version is the latest version of BetaFlight. The current (2021/03/12) is version 4.2.8. For a better experience, please wait for the release of version 4.3.0.

1. Connect VTX UART to FC’s serial port, such as UART3.

2. In the Ports interface, turn on the MSP function corresponding to the Identifier (UART3), the baud rate is 115200, Save and Reboot.

3. After opening the CLI, make the following settings:

A.  Set osd_device to msp: 
set osd_displayport_device = MSP
B.  Specify the serial port of msp_displayport as 2 (the number in this place should be the serial port number minus 1): 
set displayport_msp_serial = 2
C. Save and exit: 
save
The setup is complete.